For years afterward
there was very little change in constructing the pilots from that
originally applied to the "John Bull."
The spiral spring, which held the front wheels of the pilot in place,
acted substantially as the center pin of a truck. The turntables in
use on the road were so short that it was necessary to unconnect and
take off these pilots before turning the engine. After the pilot was
adopted the forward large wheel on right of the engine was made loose
on the shaft in order to afford additional play in going around
curves. Other[6] changes and additions were also made in the
locomotive.
[Footnote 6: Changes in the locomotive "John Bull" since date of
construction, 1830:
Steam dome changed from rear of boiler forward to a part over what
was called the "man-hole," and throttle valve placed therein.
Steam pipes changed to outside of boiler, connecting new dome with
smoke box, entering it on each side.
In the beginning the reverse gear was changed from one single
eccentric rod on each side to two on each side, connecting on to
the same eccentric wheel, and the lifting rod, in pulling back,
lifted the forward gear hook off the rocker arm, and the back
motion hook then connecting on the rocker arm reversed the engine.
Pages:
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101